New compact design allows more floor space. The potentiometer has a 25k ohm resistance suitable for the audio path of buffered, active, or line level instruments. Not for use with passive guitar signals in line before the amp input unless the BUFFER is added. Works in some effects loops.
Behind the jack area under the footplate is a micro taper switch which provides the user two distinct volume swell rates.
A tuner output is provided and allows silent tuning when the pedal is in the heel down position.
The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends. Tough long lasting Kevlar cable transmits pedal travel to the controls and is attached by stainless steel springs.
For use as an expression control pedal, also buy the HOSA Insert Y-Cable.
This pedal is 3.5" wide x 10" long x 2.25" tall.
The normal size Ernie Ball pedals are 4" W x 11" L x 2.5" H.
We can also add the Analog Man Buffer into the pedal. It goes before the volume pot so your signal will not get loaded down, and makes the Ernie Ball output nice and strong - no more tone sucking! See our
buffer page for more info.NOTE : The pots in these can make a little noise when you run them with active circuitry like our buffer. So if you are playing in a quiet church with a cranked 100 Watt Marshall, you may hear some noise when you move the pedal up and down.
Works how it should. 
